HVAC and Controls Technical Reference Atlas
Maintained since 2016, this 2026 technical atlas defines 15 core HVAC filtration, Aprilaire humidifier, and 24VAC thermostat engineering terms.

- Filterable technical definitions cover Airflow and Filtration, Humidification Hardware, 24VAC Control Wiring, and Diagnostics.
- Every entry pairs standardized HVAC nomenclature with measurable physical units such as in. w.c., GPD, Ohms, and VA.
How to Use the Equipment Reference Atlas
This reference atlas standardizes the acronyms, electrical terminal designations, and fluid-flow metrics used across National Equipment Parts Archive guides and category hubs. Entries are grouped into four technical domains so service technicians, facility managers, and homeowners can verify exact definitions without ambiguity.
Scope and Measurement Conventions
All pressure metrics follow North American HVAC conventions in inches of water column (in. w.c.), airflow in cubic feet per minute (CFM) or feet per minute (FPM), electrical control signals in 24VAC Class 2 ratings, and evaporative output in gallons per day (GPD).
MERV (Minimum Efficiency Reporting Value)
ASHRAE 52.2 scale from 1 to 16 rating an air filter's ability to capture particles between 0.3 and 10.0 microns at a specified face velocity.
Total External Static Pressure (TESP)
Combined airflow resistance in inches of water column (in. w.c.) across the filter, evaporator coil, supply ductwork, and return plenum.
Face Velocity (FPM)
Linear speed of air passing perpendicular through the filter media face, measured in feet per minute and typically rated at 300 to 500 FPM.
Deep-Bed Pleated Media
4-inch to 5-inch thick extended-surface filter cartridge designed to hold higher dust loads at lower initial pressure drop than 1-inch panels.
Hydrophilic Ceramic Coating
Porous mineral slurry applied to expanded aluminum Aprilaire water panels to promote uniform capillary wicking and adiabatic evaporation.
Metering Orifice
Precision-drilled brass or polymer restrictor installed in the humidifier solenoid outlet to cap water flow at roughly 3 gallons per hour.
Gallons Per Day (GPD)
Rated moisture evaporation capacity of a whole-house humidifier operating continuously under standard 120F plenum air conditions.
Grains Per Gallon (GPG)
Measurement of dissolved calcium and magnesium mineral hardness in supply water; levels above 10 GPG accelerate water panel scaling.
Common Wire (C-Terminal)
Dedicated return conductor completing a continuous 24VAC circuit back to the air handler transformer for powering smart thermostat electronics.
Power Extender Kit (PEK)
Multiplexing module installed at the furnace control board allowing a 4-wire thermostat cable to power an Ecobee without a separate C wire.
O/B Reversing Valve Terminal
24VAC thermostat output that shifts a heat pump four-way reversing valve between cooling mode (O) and heating mode (B).
Equipment Interface Module (EIM)
Air-handler-mounted relay hub used in Honeywell RedLINK systems to handle multi-stage HVAC and accessory wiring wirelessly.
Volt-Ampere (VA) Rating
Apparent power capacity of a 24VAC Class 2 control transformer, commonly 40VA to 75VA in residential forced-air equipment.
Condensate Float Switch
Normally closed safety switch placed in an evaporator drain pan that opens the 24VAC R or Y circuit if standing water is detected.
Outdoor Temperature Sensor (ODT)
10k Ohm NTC thermistor mounted outside the building envelope to automatically lower indoor humidity targets during sub-freezing weather.
Technical Frequently Asked Questions
How are terms selected for the Equipment Reference Atlas?
Terms are selected from recurring OEM installation manuals, Aprilaire water panel specifications, and 24VAC thermostat wiring schematics indexed in our archive since 2016.
Are these definitions applicable to both residential and light-commercial HVAC?
Yes. Standard MERV ratings, static pressure limits, and 24VAC terminal designations apply across residential split systems and light-commercial packaged rooftop units.
